The grey circle represents the soft tip for polishing work. It is considered the working part of the polishing machine. It copes well with risks, leveling the surface. It is used after analogues that provide hard grinding of surfaces.
The polishing wheel reproduces the work of sandpaper, but does it more quickly and efficiently. The soft structure eliminates the appearance of additional scratches. A level setting provides the correct contact angle with the surface, reduces wheel wear and does not put as much strain on the polisher’s hands. For high-quality fixation, a threaded sleeve is located on the reverse side, which is necessary for screwing the grinding machine spindle.
The porous polymer absorbs used oils and absorbs the heat generated due to mechanical movements. After cleaning with water, the circle cannot be immediately taken to work, because it must dry out.
15-20 g of paste is applied to the circle: it is enough to finish a plot of 35-40 cm². First, we turn on the machine in small revolutions, move it horizontally over the surface, then vertically. Then you can increase the speed of rotation of the circle. Permissible speed: 300-2500 rpm.
Don’t forget about surface preparation. Traces of midges, bitumen, street dust, bird “surprises” usually accumulate on the paintwork. After washing, soot and small grains of sand may remain on the surface. If you give up on this, the disc will smear all the dirt on the surface, and the sand will additionally scratch new marks on the paint.
For professional use only.